Figure 2.2 Front View Of 3.5" Type Controller Enclosure (Without Front Cover); Figure 2.3 Disk Slot Numbers (3.5" Type Controller Enclosure) - Fujitsu Eternus DX60 User Manual

Chapter 2 Components
2.1 3.5" Type Controller Enclosure
■
Without front cover
Figure 2.2
■
Disk slot numbers
Figure 2.3
Figure 2.3
DISK READY/FAULT LED
Glows ( ) or blinks green (
are operating normally.
Glows orange ( ) when a disk has failed.
Blinks orange ( ) according to the VDS (Microsoft Virtual Disk Service) commands.
Disk
Up to 12 disks can be installed in the ETERNUS DX60/DX80/DX90.
AUTO POWER Switch
Enables the AC Auto-Link Mode
(This function automatically turns on the linked
device once AC power is supplied).
This switch is set to "OFF" as the factory setting.
MODE SELECT Switch
Enables the device power to be turned on via
power linkage
This switch is set to "ON" as the factory setting
and should not be set to "OFF".
IP RESET Switch
For dual controller model, click once to switch
the Master CM LAN port from the current controller
to the other controller.
Click twice in succession within a two second
interval to revert the LAN port settings of the
ETERNUS DX60/DX80/DX90 to their factory settings.
Front view of 3.5" type controller enclosure (without front cover)
shows the slot number of each disk.
Slot#8 Slot#9
Slot#4 Slot#5
Slot#0 Slot#1
Disk slot numbers (3.5" type controller enclosure)
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
) when disks
Slot#10 Slot#11
Slot#6 Slot#7
Slot#2 Slot#3
50
P3AM-3042-08ENZ0