Attaching And Removing The Flange Cover - Fujitsu Eternus DX60 User Manual

Chapter 3 Standard Operations

3.4 Attaching and Removing the Flange Cover

3.4 Attaching and Removing the Flange Cover
This section explains how to attach and remove the flange cover of the 2.5" type controller
enclosure and the 2.5" type drive enclosure.
■
Procedure for attaching the flange cover
Attach the flange cover in the following order.
Procedure
1
Do
CAUTION
• At the completion of this operation, check that the flange cover is
attached.
This section explains how to attach and remove the flange cover of the 2.5"
type controller enclosure, but the same procedure is used to attach and
remove the flange cover of the 2.5" type drive enclosure.
Slide the tab inside the top of the flange cover over the top-left corner of the controller
enclosure.
When fitting the flange cover, be careful not to touch the power
IMPORTANT
switch (
Flange cover
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
).
78
P3AM-3042-08ENZ0