Fujitsu Eternus DX60 User Manual page 115
Disk storage system
Hide thumbs
Also See for Eternus DX60:
- User manual (239 pages) ,
- Operation manual (119 pages) ,
- Product introduction (19 pages)
Table of Contents
Advertisement
Chapter 6 Cable Connection
6.4 LAN Cable Connection (For iSCSI)
■
LAN cable connection procedure
The following explains how to connect the LAN cable.
IMPORTANT
Procedure
1
Do Not
CAUTION
•
Do not bend the cable too much or bind it up. Doing so may cause a
device damage or failure.
Do not bend square
•
To help with LAN cable management and prevent incorrect connections,
attach labels to the LAN cables and make a note of connection origins
and destinations.
•
When connecting LAN cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the
connector.
This section describes dual controller model as an example. Note that there
is only controller 0 (CM#0) for single controller model.
Connect the LAN cable to the ETERNUS DX60/DX80.
Insert the LAN cable connectors in the controller 0 (CM#0) and controller 1 (CM#1) iSCSI
ports.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
90
Do not bind up
115
P3AM-3042-08ENZ0
Advertisement
Table of Contents
