Iscsi Initiator; System Console Screen - HP StorageWorks D2D100 - Backup System User Manual

Figure 25 System console screen
4.
Locate the IP address for the port(s) and make a note of it.
5.
Use an iSCSI Initiator to enable the host to connect to devices on the HP D2D, see also
"iSCSI Initiator" on page 49. In the web browser on the host machine, type in the IP address of
the HP D2D to connect to it.

iSCSI Initiator

NOTE:
If you have a FC product, you may configure it to have a mixture of FC and iSCSI attached devices.
If you are configuring your HP D2D to have iSCSI devices (for hosts attached via the LAN ports), this
section is relevant. However, if you are configuring it to have only FC network devices (attached via
the FC ports), it is not necessary; you use the Web Management interface to create FC devices, see
"To create a new
iSCSI is a protocol for sending SCSI commands via Ethernet. It defines how SCSI packets are translated
to Ethernet packets and connects to the required devices. An iSCSI initiator may be hardware or software
and should be running on each host. If the host does not have an iSCSI initiator, it will not be able to
connect to the library configured on the HP D2D Backup System and will not be able to perform backups.
device" on page 72.
D2D Backup SystemHP D2D4004 and HP D2D4009
49