Beacon Mode - HP StorageWorks D2D100 - Backup System User Manual

Beacon mode

The HP D2D Backup System supports a Beacon LED sequence, which helps a user identify which unit is
being configured, if several are connected to the network. There is also a Beacon LED on the individual
disks so that you can identify a specific disk within the HP D2D.
Use the Network page of the Web Management Interface to turn Beacon Mode on and off for the HP D2D
Backup System. This turns the Beacon LED on the front and the rear of the HP D2D solid blue. If you do not
switch off Beacon Mode, it will continue for 5 minutes. See also "Network (Configuration)" on page 77.
You can also switch Beacon mode on and off by pressing the LED on the front panel.
Use the RAID page of the Web Management Interface to turn Beacon Mode on and off for a specific
disk. This turns the Beacon LED on the disk solid blue. See also "RAID (Status)" on page 82.
66 LEDs