Network (Configuration); To Edit Network Settings - HP StorageWorks D2D100 - Backup System User Manual

NOTE:
When you import a cartridge, you need an empty mail slot and an empty cartridge to which the backup
application can move the imported data. Therefore, you may wish to leave a slot whose cartridge has
been exported empty, rather than creating a new cartridge. Or to create a slot, edit the Total No Of
Cartridge Slots on the Devices page, see
Network (Configuration)
This page is used to view and edit network settings. It is also used to turn Beacon Mode on and off.
Network configuration
The details in this section reflect the IP settings that were specified during installation. The HP D2D Backup
System supports DHCP for IPv4 networks and this is turned on by default.
You may need to edit the details if there is a conflict in the IP address, or you move the host to a different
network node. Be aware that any changes you make to the network settings could affect how you
connect again to the HP D2D Backup System. For example, if you change the IP address, you must use
the new address to log in from a web browser.

To edit network settings

1. Click Edit to make the details editable.
2. Make the required changes and click Update.
"To edit device details" on page 71.
D2D Backup SystemHP D2D4004 and HP D2D4009
77