HP StorageWorks D2D100 - Backup System User Manual page 34

When the configuration page for the device is displayed, DHCP is enabled by default
for IPv4 networks. If you wish to use static IP addressing, disable DHCP and enter the
IP address details.
TIP:
If more than one HP D2D Backup System is being configured at the same time, it may be useful
to physically identify a D2D device. Use Beacon mode to flash the LED on the selected device.
For IPv6–only networks you must enter the MAC address of the HP D2D. You will find
the MAC address on the label on the top of the unit. The wizard translates the MAC
address into a valid IPv6 address for your network. If it is unable to do this, refer to
"Using the system console to discover the HP
• Create desktop shortcut to the Web Management Interface.
• Create base library device on the HP D2D:
If you are configuring the HP D2D as an iSCSI device, this step retrieves and installs the
Microsoft iSCSI initiator, connects this host to the HP D2D Backup System and creates
34
Connecting and installing the HP D2D Backup System
D2D" on page 47.