Emulation Types For Tape Devices; Device Parameters (Top Half Of The Page) - HP StorageWorks D2D100 - Backup System User Manual

The top half of the page shows the a list of devices available on the HP D2D Backup System. Summary
information is provided for each device, as follows:
Table 5 Device parameters (top half of the page)
Name
Cartridges
Connection
Device Type
Port

Emulation types for tape devices

HP D2D products emulate a range of physical tape devices, these are either Tape Autoloaders or Tape
Libraries. Supported emulation types are listed below:
70
The Web Management Interface
This is the name that is used to identify that device (library or autoloader). You may
like to enter a name that identifies the host or backup job with which it is associated.
This is the number of cartridges available on the device, which is determined by the
Emulation Type selected when the device was created.
If a device is shown as not connected, this indicates that the iSCSI Initiator on the
host has not logged on. For more information, see
With a FC device, this field shows the connection status of the FC link and its speed
(down, 1G, 2G, 4G).
This is the emulation type used by the backup software. It is selected during
installation or when you create a device.
This identifies the port to which the host is connected for backup and restore. The
number of ports available in the drop-down menu depends upon your network
configuration.
There are two LAN ports on the rear of the HP D2D. LAN port 1 must always be
connected to install the software and run the Web Management Interface. If both
ports are connected, you will be able to choose which one will be used to transfer
backup data to and from the host in the drop-down menu. If only one port is
connected, there will be only one LAN port choice (port 1).
If you have the FC model, there are also two FC ports on the pre-installed FC card
and additional choices for transferring backup data in the Port drop-down menu.
"Targets tab" on page 54.