Targets Tab; Add Target Portal - HP StorageWorks D2D100 - Backup System User Manual

Figure 30 Add target portal
You must enter the IP address or fully qualified domain name of the HP D2D Backup System (for example,
myhpd2d.mydomain.com) to add it as a target portal for the host on the Discovery tab. Do not change
the Port; it should be 3260.

Targets tab

This tab contains a list of all available devices.
• If this is the first time that the iSCSI Initiator has been configured and the Installation wizard has
not been run, it will automatically create a library with the appropriate number of target devices
(the default is one loader and one tape drive).
• If target devices have already been configured for the host in the past, they appear in the list;
no more are created.
When you run the iSCSI Initiator manually, new devices have a status of Inactive. You must log on to
the appropriate targets for your host. Remember that each library has at least two devices and you
must log onto each one separately. If the emulation type you have selected allows more drives, there
will be a target device for each drive.
NOTE:
If you are using mutual CHAP authentication, you set up the details when you log on to the target.
If you are using a dual port configuration, there will be two IP addresses in separate subnets for each
device. The iSCSI initiator will return both IP addresses as possible login addresses. If the default choice
does not work you can select a specific port. High Availability dual ports return a single IP address. See
also "Dual network
54
Advanced installation
ports" on page 30.