Resetting The Password; Shutdown (Settings) - HP StorageWorks D2D100 - Backup System User Manual

Resetting the password

If you forget your password, you can reset the HP D2D Backup System as follows:
NOTE:
Resetting the password will reset the networking settings to the factory defaults and reset the Administrator
password to Admin. No user data will be lost.
1.
Make sure nobody is using the HP D2D Backup System before you attempt the reset.
2. Press the Power button on the front of the HP D2D Backup System three times in quick succession.
Approximately 5 seconds later the HP D2D Backup System will reboot.
3. Use the device discovery tool on the HP StorageWorks CD-ROM to re-configure the network settings
of the HP D2D Backup System.

Shutdown (Settings)

This option allows you to shut down the HP D2D Backup System cleanly. It is the only recommended
way of powering off the device. If you remove the power in any other way and a host is carrying out a
backup or restore, you may lose or corrupt data.
Click Power Off and Yes to confirm.
86
The Web Management Interface