Initializing Raid; Create Cartridges; System Console After Three Disks Are Replaced - HP StorageWorks D2D100 - Backup System User Manual
Hp storageworks d2d4004 and hp d2d4009 backup system user guide (eh938-90924, october 2008)
Hide thumbs
Also See for StorageWorks D2D100 - Backup System:
- Release note (4 pages) ,
- User manual (41 pages) ,
- User manual (176 pages)
Table of Contents
Advertisement
Figure 54 System console after three disks are replaced
Initializing RAID
You must initiate the RAID rebuild manually on the RAID page in the Web Management Interface. Click
on the Initialise button. This will make the HP D2D Backup System usable again, but you will have lost
your data. After initialization, the Disk page will show 0% used because all data has been lost.
The initialization process takes approximately 3 to 5 minutes.
Create cartridges
All cartridges and data were lost when the disks failed. Before you can use the HP D2D Backup System
you must create new cartridges.
132
Hard disk replacement
Advertisement
Table of Contents
