4 HP-UX 1 1i V2/V3 (PA-RISC & IA64)
Overview
This chapter describes how to configure the HP StoreOnce Backup System for use with the following
HP-UX operating systems:
HP-UX 1 1i V2 (PA-RISC and IA64)
HP-UX 1 1i V3 (PA-RISC and IA64)
NOTE:
A block size no larger than 256 KB is strongly recommended when working with HP-UX
1 1i V2. See
Using large block sizes with HP-UX 1 1i V2 (page
Configuring the HP StoreOnce Backup System for iSCSI
If your product supports iSCSI use the information in this section to configure it.
If your product does not support iSCSI, go to
Channel (page
How to install the iSCSI software initiator
The iSCSI Software Initiator is located at the HP Software Depot.
1.
Go to http://www.software.hp.com.
2.
Enter iSCSI Software Initiator in the search box.
3.
When the search results show iSCSI Software Initiator, click on Receive for Free.
4.
In the Software Specification window, highlight the HP-UX version on which you want to install
the HP-UX iSCSI Software Initiatot.Then complete the required fields and click on Next >>
5.
Look for Download Software, then click on the iSCSI Software Initiator version that you would
like to download.
6.
In the Document column (next to the Download Software column), click on Installation Instruction
to download instructions for using the Software Distributor tool to install the iSCSI Software
Initiator.
NOTE:
provides an interface for removing software from HP-UX systems.
7.
After the system reboots, verify that the installation was successful by issuing the swlist
command as follows:
swlist iSCSI-00
If the HP-UX iSCSI Software Initiator is installed correctly, the output will be:
HP-UX 1 1i V2
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/
#
# iSCSI-00 B.11.23.03e HP-UX iSCSI Software Initiator
iSCSI-00.ISCSI-SWD B.11.23.03e HP-UX iSCSI Software Initiator
HP-UX 1 1i V3
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/
#
21).
The Software Distributor is used for software installations on HP-UX systems. It also
24).
Configuring the HP Backup System for Fibre
Overview
17