Replacing The Hard Disk; Log Showing Disk Failure; Disk Numbering - HP StorageWorks D2D100 - Backup System User Manual
Hp storageworks d2d4004 and hp d2d4009 backup system user guide (eh938-90924, october 2008)
Hide thumbs
Also See for StorageWorks D2D100 - Backup System:
- Release note (4 pages) ,
- User manual (41 pages) ,
- User manual (176 pages)
Table of Contents
Advertisement
Figure 45 Log showing disk failure
Replacing the hard disk
1.
Identify the disk that has failed as described in
2.
The hard drives installed in the server are labeled from device 1 to device 12, from left to right, top
to bottom, when viewed from the front of the server.
Figure 46 Disk numbering
3.
Remove the disk.
• Press the hard disk carrier button (1) to release the ejector lever.
• Use the HDD carrier latch (2) to pull the drive out of the cage. Be sure to support the drive when
pulling it out of the cage.
• Pull the hard drive assembly (3) out of the drive bay.
"How do I know a disk has
D2D Backup SystemHP D2D4004 and HP D2D4009
failed?" on page 123.
127
Advertisement
Table of Contents
