Configuration Server Protocol; Configuring The Configuration Server Protocol - Aastra 9143i Series Administrator's Manual

IP Phone Administrator Guide

Configuration Server Protocol

Configuration Server Protocol
You can download new versions of firmware and configuration files from the
configuration server to the IP phone using any of the following types of protocols:
TFTP, FTP, HTTP, and HTTPS. For each Protocol, you can specify the path for
which the configuration files are located on the server. For HTTP and HTTPS,
you can also specify the port number to use for downloading the phone
configuration. For FTP, you can configure a Username and Password that are
authenticated by the FTP server.
The TFTP setting is the default download protocol. You can configure the type of
protocol that the IP phones use by setting it in the configuration files, the IP phone
UI, or the Aastra Web UI.

Configuring the Configuration Server Protocol

Use the following procedure to configure the configuration server protocol.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Server Settings" on page A-18.
4-108
Note: For DHCP to automatically populate the IP address or domain
name for the TFTP, FTP, HTTP, or HTTPS server, your DHCP server
must support download protocol according to RFC2131 and RFC1541 for
Option 66. For more information, see this chapter, the section,
on page 4-4.
"DHCP"
"Configuration
41-001160-03, Rev 00, Releaes 2.4