Message Waiting Indicator Line - Aastra 9143i Series Administrator's Manual

Message Waiting Indicator Line

A User or Administrator can configure the Message Waiting Indicator (MWI) to
illuminate for a specific line or for all lines. For example, if you configure the
MWI LED on line 3 only, the LED illuminates if a voice mail is pending on line 3.
If you configure the MWI LED for all lines, the LED illuminates if a voice mail is
pending on any line on the phone (lines 1 through 9).
A User can configure the MWI using the Aastra Web UI only. An Administrator
can configure the MWI on single or all lines using the configuration files or the
Aastra Web UI.
Configuring Message Waiting Indicator (MWI)
Use the following procedures to configure MWI on the IP phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Waiting Indicator Settings"
41-001160-03, Rev 00, Releaes 2.4
on page A-153.
Configuring Operational Features
Operational Features
"Message
5-89