Aastra 9143i Series Administrator's Manual page 456

IP Phone Administrator Guide
Operational Features
Feature Key Programming Guidelines
The following are guidelines to use when programming the feature keys on the
handset:
• All handsets paired with the same Base Station have the same programmed
functions since the web interface applies the functions to all the handsets
paired with that base.
• A newly registered handset or handset that was out-of-range during the
programming needs to perform an "off-hook and on-hook" sequence in order
for the newly programmed function to be broadcasted to the affected
handsets. Simply press the v key from the idle state to go off-hook. Then,
press the
• Duplicate functions can exist in the feature key as there is no filtering or
duplicate checking done on the handset or the base.
• If no line keys are programmed for the feature key, the handset is restricted to
intercom calls only.
• If all 12 programmable functions have been programmed to "None", the user
is presented with a List empty message when the feature key is pressed.
• For security reasons, the user has 180 seconds (3 minutes) to complete the
programming. Otherwise, the phone displays the following error:
** Error **: Session expired, Please reload page.
• For security reasons, the user must submit the page from the same browser
that was used to load the page. If the user tries to submit the page from any
other IP address, the following error displays:
** Error ** Session invalid. Different Client IP Addresses. —
Please reload page
5-158
y
key to go back on-hook.
List empty
Use web page to
configure
41-001160-03, Rev 00, Releaes 2.4