Lenovo ThinkServer TS200 Hardware Maintenance Manual page 53

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• SeeChapter 7 "Parts listing, TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530" on page 209
to determine which components are customer replaceable units (CRU) and which components are field
replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a trained service technician.
Hostname set to %1
by user %2.(%1 =
CIM_DNSProtocolEndpoint.Hostname;
%2 = user ID)
IP address of network
interface modified from %1
to %2 by user %3.(%1 =
CIM_IPProtocolEndpoint.IPv4Address;
%2 =
CIM_StaticIPAssignmentSettingData.IPAddress;
%3 = user ID)
IP subnet mask of network
interface modified from %1
to %2 by user %3s.(%1 =
CIM_IPProtocolEndpoint.SubnetMask;
%2 =
CIM_StaticIPAssignmentSettingData.SubnetMask;
%3 = user ID)
IP address of default
gateway modified from %1
to %2 by user %3s.(%1 =
CIM_IPProtocolEndpoint.GatewayIPv4Address;
%2 =
CIM_StaticIPAssignmentSettingData.DefaultGatewayAddress;
%3 = user ID)
OS Watchdog response %1 by
%2.(%1 = Enabled or Disabled; %2
= user ID)
DHCP[%1] failure, no IP address
assigned.(%1 = IP address,
xxx.xxx.xxx.xxx)
Remote Login Successful.
Login ID: %1 from %2 at IP
address %3.(%1 = user ID; %2 =
ValueMap(CIM_ProtocolEndpoint.ProtocolIFType;
%3 = IP address, xxx.xxx.xxx.xxx)
Attempting to %1 server %2 by
user %3.(%1 = Power Up, Power
Down, Power Cycle, or Reset; %2 =
IBM_ComputerSystem.ElementName;
%3 = user ID)
Info A user has modified the host
name of the IMM.
Info A user has modified the IP
address of the IMM.
Info A user has modified the IP
subnet mask of the IMM.
Info A user has modified the
default gateway IP address
of the IMM.
Info A user has enabled or
disabled an OS Watchdog.
Info A DHCP server has failed to
assign an IP address to the
IMM.
Info A user has successfully
logged in to the IMM.
Info A user has used the IMM to
perform a power function on
the server.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
No action; information only.
1. Make sure that the network
cable is connected.
2. Make sure that there is a DHCP
server on the network that can
assign an IP address to the
IMM.
No action; information only.
No action; information only.
.
Chapter 4 Diagnostics
45