Ids For Hot-Swap Hard Disk Drives - Lenovo ThinkServer TS200 Hardware Maintenance Manual

To remove a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page "Important Safety Information" on page 1.
Note: You do not have to turn off the server to remove hot-swap drives from the hot-swap drive bays.
2. Remove the lower bezel (see "Removing the two-piece bezel" on page 144).
3. Rotate the drive tray handle of the drive assembly that is to be removed to the open position (based
on your model).
1
Drive-tray assembly
2
Drive tray handle (in open position)
4. Grasp the handle of the drive assembly that is to be replaced and pull the assembly out of the bay.
5. If you are instructed to return the drive assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

IDs for hot-swap hard disk drives

On some models, the hot-swap-drive backplane controls the IDs of the internal hot-swap drive bays. The
following table lists the IDs of the hard disk drives and backplane that are connected to one channel in the
hot-swap models. In the typical configuration, the standard hard disk drives and backplane are connected to
channel A. This table applies only to server models that support four hard disk drives.
Table 14. IDs of the hot-swap drives (models with four drive bays)
Drive bay
4
5
158
Hardware Maintenance Manual
ID
0
1