Replacing The Battery; Removing The Battery - Lenovo ThinkServer TS200 Hardware Maintenance Manual

5. Install the eight screws (seven in front and one in rear) that secure the system board to the chassis.
6. Install any of the following components that you removed from the system board:
• The fan connector covers.
• Hypervisor key (see "Installing a USB embedded hypervisor flash device" on page 172).
• Virtual media key (see "Installing the virtual media key" on page 173).
• SAS/SATA controller (see "Installing a ServeRAID BR10-il controller" on page 167).
• Battery (see "Installing the battery" on page 199).
• DIMMs (see "Installing a memory module" on page 150).
• Microprocessor and fan sink (see "Installing the microprocessor and fan sink" on page 193).
• Adapters (see "Installing an adapter" on page 163).
7. Press and hold the retaining tab on top of the cage; then, rotate the drive cage into the chassis until it
locks into place.
8. Reconnect any cables to the system board that you disconnected during removal.
9. When a new system board is installed, you must update the UUID and the DMI/SMBIOS data. See
"Updating the Universal Unique Identifier (UUID)" on page 203 and "Updating the DMI/SMBIOS data" on
page 205.
10. Go to "Completing the FRU replacement" on page 200.

Replacing the battery

Use the following procedures to replace the battery.

Removing the battery

To remove the battery, do the following:
1. Read the safety information that begins on page "Important Safety Information" on page 1.
198
Hardware Maintenance Manual