Replacing Internal Drives - Lenovo ThinkServer TS200 Hardware Maintenance Manual

1. Read the safety information that begins on page "Important Safety Information" on page 1.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if
necessary.
3. Remove the cover (see "Removing the side cover" on page 142).
4. Open the retaining clip on each end of the DIMM connector.
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and close
the clips gently.
5. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the
outside of the server. Then, remove the DIMM from the package.
6. Turn the DIMM so that the DIMM keys align correctly with the connector.
7. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the
DIMM connector (see "System-board internal connectors" on page 131 for the location of the DIMM
connectors).
8. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the
DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated
in the connector.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly
inserted; open the retaining clips, remove the DIMM, and then reinsert it.
9. Go to "Completing the FRU replacement" on page 200.

Replacing internal drives

See "Specifications" on page 9 for information about the types of drives that the server supports and other
important information. The following figure shows the locations of the drive bays in the server.
.
Chapter 6 Replacing FRUs
151