Lenovo ThinkServer TS200 Hardware Maintenance Manual page 285

a. Download the latest version of the IMM firmware from http://www.lenovo.com/support.
b. Update the IMM firmware, following the instructions that come with the update file that you
downloaded.
3. Configure the UEFI settings:
a. When you are prompted to start the Configuration/Setup Utility program, restart the server and
press F1.
b. Select System Settings ® Devices and I/O Ports.
c. Select Console Redirection Settings; then, make sure that the values are set as follows:
• COM Port 1: Enable
• Remote Console: Enable
• Serial Port Sharing: Enable
• Serial Port Access Mode: Dedicated COM1 Settings
• Baud Rate: 115200
• Data Bits: 8
• Parity: None Stop
• Bits: 1
• Thermal Emulation: ANSI
• Active After Boot: Enable
• Flow Control: Hardware
d. Press Esc twice to exit the Devices and I/O Ports section of the Configuration/Setup Utility program.
e. Select Save Settings; then, press Enter.
f. Press Enter to confirm.
g. Select Exit Setup; then, press Enter.
h. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.
.
Chapter 8 Configuring the server
277