Installing The Sas/Sata Hard Disk Drive Backplane; Replacing The Front-Panel Assembly - Lenovo ThinkServer TS200 Hardware Maintenance Manual

Installing the SAS/SATA hard disk drive backplane

This procedure applies only to hot-swap server models with a SAS/SATA hard disk drive backplane installed
on the back of the hard disk drive cage.
To install the hard disk drive backplane, complete the following steps:
1. Place the bottom edge of the SAS/SATA hard disk drive backplane in the lower lip of the drive cage.
2. Tilt the top of the SAS/SATA hard disk drive backplane toward the drive cage and over the locating pins.
1
Locating pins
2
Retaining tab
3
Retaining latch
4
Drive cage release tab
3. Install the two screws that secure the SAS/SATA hard disk drive backplane to the drive cage.
4. Press and hold the retaining tab on top of the cage; then, rotate the drive cage into the chassis until it
locks into place.
5. Connect the power and signal cables to the hard disk drive backplane.
6. Install the hard disk drive fan assembly onto the hard disk drive cage (see "Installing the hard disk drive
fan assembly" on page 177).
7. Install the hot-swap hard disk drives that you removed from the hard disk drive cage (see "Installing a
hot-swap hard disk drive" on page 159).
8. Go to "Completing the FRU replacement" on page 200.

Replacing the front-panel assembly

Use the following procedures to replace the front-panel assembly.
182
Hardware Maintenance Manual