Installing The Side Cover - Lenovo ThinkServer TS200 Hardware Maintenance Manual

To replace the side cover, see "Installing the side cover" on page 143.
Attention: For proper cooling and airflow, replace the cover before turning on the server. Operating the
server for extended periods of time (more than 30 minutes) with the cover removed might damage server
components.

Installing the side cover

Attention: For proper cooling and airflow, replace the side cover before turning on the server. Operating
the server for extended periods of time (more than 30 minutes) with the side cover removed might damage
server components.
To install the side cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and seated correctly and that
you have not left loose tools or parts inside the server. Also, make sure that all internal cables are
correctly routed.
2. If you removed the upper and lower bezels, reinstall them before you replace the side cover (see
"Installing the upper bezel" on page 146 and "Installing the lower bezel" on page 145).
Important: The cover lock must be in the unlocked (opened) position before you install the side cover.
3. Position the lip on the bottom edge of the side cover on the ledge on the bottom of the chassis; then,
rotate the cover up to the chassis. Press down on the cover release latch and push the cover completely
closed until it latches securely into place.
.
Chapter 6 Replacing FRUs
143