Using The Integrated Management Module - Lenovo ThinkServer TS200 Hardware Maintenance Manual

Table 33. System board jumpers
Jumper number
JP1
JP6
Notes:
1. If no jumper is present, the server responds as if the pins are set to 1 and 2.
2. Changing the position of the UEFI boot recovery jumper from pins 1 and 2 to pins 2 and 3 before the server is
turned on alters which flash ROM page is loaded. Do not change the jumper pin position after the server is
turned on. This can cause an unpredictable problem.

Using the integrated management module

The integrated management module (IMM) is a second generation of the functions that were formerly
provided by the baseboard management controller hardware. It combines service processor functions, video
controller, and (when an optional virtual media key is installed) remote presence function in a single chip.
The IMM supports the following basic systems-management features:
• Environmental monitor with fan speed control for temperature, voltages, fan failure, and power supply
failure.
• DIMM error assistance. The Unified Extensible Firmware Interface (UEFI) disables a failing DIMM that is
detected during POST, and the IMM lights the associated system error LED and the failing DIMM error LED.
• System-event log (SEL).
• ROM-based IMM firmware flash updates.
• Auto Boot Failure Recovery (ABR).
• A virtual media key, which enables remote presence support (remote video, remote keyboard/mouse,
and remote storage).
• Nonmaskable interrupt (NMI) detection and reporting.
• Automatic Server Restart (ASR) when POST is not complete or the operating system hangs and the
operating system watchdog timer times-out. The IMM might be configured to watch for the operating
system watchdog timer and reboot the system after a timeout, if the ASR feature is enabled. Otherwise,
the IMM allows the administrator to generate a nonmaskable interrupt (NMI) by pressing an NMI button on
the system board for an operating-system memory dump. ASR is supported by IPMI.
• Intelligent Platform Management Interface (IPMI) Specification V2.0 and Intelligent Platform Management
Bus (IPMB) support.
• Invalid system configuration (CNFG) LED support.
• Serial port redirection over Telnet or SSH.
• Serial over LAN (SOL).
• Query power supply input power.
• PECI 2 support.
Jumper name
1
Clear CMOS jumper
2
Boot block jumper
Jumper setting
• Pins 1 and 2: Keep CMOS data
(default).
• Pins 2 and 3: Clear CMOS data
(including power-on password and
administrator password)
• Pins 1 and 2: Boot from primary
BIOS page (default) .
• Pins 2 and 3: Boot from backup
BIOS page.
.
Chapter 8 Configuring the server
271