Lenovo ThinkServer TS200 Hardware Maintenance Manual page 110

Table 5. DSA Preboot messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 7 "Parts listing, TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530" on page 209
to determine which components are customer replaceable units (CRU) and which components are field
replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a Trained service technician.
• Go to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Message
number Component Test
201-801-xxx Memory
201-802-xxx Memory
102
Hardware Maintenance Manual
State
Memory Test Aborted
Memory Test Aborted
Description Action
Test canceled: 1. Turn off and restart the system.
the system UEFI
2. Run the test again.
programmed
3. Make sure that the server firmware
the memory
is at the latest level. The installed
controller with
firmware level is shown in the DSA
an invalid CBAR
event log in the Firmware/VPD
address
section for this component. For
more information, see "Updating
the firmware" on page 269.
4. Run the test again.
5. If the failure remains, go to
the Lenovo Web site for more
troubleshooting information at
http://www.lenovo.com/support.
Test canceled: 1. Turn off and restart the system.
the end address
2. Run the test again.
in the E820
3. Make sure that all DIMMs are
function is less
enabled in the Setup utility.
than 16 MB.
4. Make sure that the server firmware
is at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD
section for this component. For
more information, see "Updating
the firmware" on page 269.
5. Run the test again.
6. If the failure remains, go to
the Lenovo Web site for more
troubleshooting information at
http://www.lenovo.com/support.