Replacing The Simple-Swap Backplate; Removing The Simple-Swap Backplate - Lenovo ThinkServer TS200 Hardware Maintenance Manual

1
Release tabs
2
Hard disk drive fan assembly
3
Slot
2. Route the hard disk drive signal and power cables through the slots on the edge of the hard disk drive fan
assembly. Make sure that the cables will not be pinched between the hard disk drive assembly and the
hard disk drive backplane when the assembly is installed.
3. Rotate the hard disk drive fan assembly toward the backplane. Align the right edge of the hard disk
drive fan assembly and the right edge of the backplane. Make sure the release tabs are fully engaged
on the drive cage.
4. Rotate the drive cage toward the front of the server until it stops; then, lift and hold the retaining tab
top of the drive cage while you rotate the drive cage into the chassis until it locks into place.
5. Connect the hard disk drive fan assembly cable to the system board (see "System-board internal
connectors" on page 131 for the location of the hard disk drive fan connector).
6. Reinstall the hard disk drives.
Note: Before you continue, check all internal power cables to be sure that they are connected to the
system board and other optional devices.
7. Go to "Completing the FRU replacement" on page 200.

Replacing the simple-swap backplate

Use these procedures to replace the simple-swap backplate. This procedure applies only to server models
with the simple-swap SATA backplate installed on the back of the hard disk drive cage.

Removing the simple-swap backplate

To remove the simple-swap backplate, complete the following steps:
Note: You need a screwdriver in order to complete the steps.
1. Read the safety information that begins on page "Important Safety Information" on page 1.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Unlock and remove the side cover (see "Removing the side cover" on page 142).
178
Hardware Maintenance Manual
1 on