5. Disconnect the hard disk drive fan assembly cable from the system board, making a note of the cable
was connected to the hard disk drive fan connector for later installation.
6. Remove the lower bezel (see "Removing the two-piece bezel" on page 144).
7. Remove the hard disk drives.
8. Lift up and hold the drive cage release tab; then, rotate the drive cage out of the chassis until the retaining
tab on top of the cage locks into place.
1
Drive cage release tab
2
Hard disk drive cage
9. Pull out on the hard disk drive fan assembly release tabs; then, rotate the assembly away from the
drive cage slightly.
176
Hardware Maintenance Manual