Completing The Fru Replacement; Reinstalling The Two-Piece Bezel - Lenovo ThinkServer TS200 Hardware Maintenance Manual

1. Follow any special handling and installation instructions that come with the replacement battery.
2. Insert the replacement battery
a. Hold the battery in a vertical orientation so that the smaller side is facing the socket.
b. Place the battery into its socket, and press the battery towards the socket until it clicks into place.
Make sure that the battery clip holds the battery securely.
3. Install and lock the left-side cover (see "Installing the side cover" on page 143).
4. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
Note: You must wait approximately 2 1/2 minutes after you connect the server power cord to an electrical
outlet before the power-control button becomes active.
5. Start the Setup Utility and reset the configuration:
• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
See "Using the Setup Utility" on page 255.
6. Go to "Completing the FRU replacement" on page 200.

Completing the FRU replacement

To complete the FRU replacement, you must:
• If removed, reinstall the two-piece bezel (see "Reinstalling the two-piece bezel" on page 200).
• If removed, reinstall the side cover (see "Reinstalling the side cover" on page 201.)
• Connect all the cables (see "Connecting the cables" on page 202.)
• For some devices, run the Setup utility (see "Using the Setup Utility" on page 255.)
Follow the instructions in this section.

Reinstalling the two-piece bezel

To reinstall the two-piece bezel, complete the following steps:
1. Install the upper bezel on the front of the server chassis:
a. Insert the two right-side tabs on the upper bezel into the matching holes on the right side of the
chassis.
b. Rotate the upper bezel to the left side of the chassis and press the bezel clips into the matching
indentations on the left side of the chassis until the bezel clips snap into place.
200
Hardware Maintenance Manual
1 :