Enabling The Remote Presence Feature; Obtaining The Ip Address For The Imm; Logging On To The Web Interface - Lenovo ThinkServer TS200 Hardware Maintenance Manual

• Remotely accessing the server, using the keyboard and mouse from a remote client
• Mapping the DVD drive, diskette drive, and USB flash drive on a remote client, and mapping ISO and
diskette image files as virtual drives that are available for use by the server
• Uploading a diskette image to the IMM memory and mapping it to the server as a virtual drive
The blue-screen capture feature captures the video display contents before the IMM restarts the server when
the IMM detects an operating-system hang condition. A system administrator can use the blue-screen
capture to assist in determining the cause of the hang condition.

Enabling the remote presence feature

To enable the remote presence feature, complete the following steps:
1. Install the virtual media key into the dedicated slot on the system board (see "Installing the virtual media
key" on page 173).
2. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button
becomes active.

Obtaining the IP address for the IMM

To access the Web interface, you need the IP address for the IMM. You can obtain the IMM IP address
through the Setup utility. The server comes with a default IP address for the IMM of 192.168.70.125. To
locate the IP address, complete the following steps:
Step 1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control
button becomes active.
When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed on the screen for
Step 2.
only a few seconds. You must press F1 quickly.) If you have set both a power-on password and
an administrator password, you must type the administrator password to access the full Setup
utility menu.
Step 3. From the Setup utility main menu, select System Settings.
Step 4. On the next screen, select Integrated Management Module.
Step 5. On the next screen, select Network Configuration.
Step 6. Find the IP address and write it down.
Step 7. Exit from the Setup utility.

Logging on to the Web interface

To log on to the Web interface to use the remote presence functions, complete the following steps:
Step 1. Open a Web browser and in the address or URL field, type the IP address or host name of the
IMM to which you want to connect.
Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMM assigns a static IP
address of 192.168.70.125.
Step 2. On the Login page, type the user name and password. If you are using the IMM for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the event log.
.
Chapter 8 Configuring the server
275