Removing A Tape Drive - Lenovo ThinkServer TS200 Hardware Maintenance Manual

1
Release buttons
2
Drive retainer clip
5. Push the drive into the bay.
6. Connect the power and signal cables to the drive (see "Power and signal cables for internal drives" on
page 161.)
Note: Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
7. Go to "Completing the FRU replacement" on page 200.

Removing a tape drive

To remove a tape drive, complete the following steps:
1. Read the safety information that begins on page "Important Safety Information" on page 1.
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Unlock and remove the side cover (see "Installing the side cover" on page 143).
4. Remove the lower bezel (see "Installing the lower bezel" on page 145).
5. Remove the upper bezel (see "Installing the upper bezel" on page 146).
6. Disconnect the power and signal cables from the drive that is to be removed.
7. Press and hold the blue release button on the side of the bay to release the drive; then, pull the drive
out of the front of the server.
8. Remove the drive retainer clip from the side of the drive. Save the clip to use when you install the
replacement drive.
.
Chapter 6 Replacing FRUs
155