Installing The Simple-Swap Backplate - Lenovo ThinkServer TS200 Hardware Maintenance Manual

4. Remove the lower bezel (see "Removing the two-piece bezel" on page 144).
5. Remove the simple-swap hard disk drives that are installed in the hard disk drive cage (see "Removing a
simple-swap hard disk drive" on page 160).
6. Remove the hard disk drive fan assembly from the hard disk drive cage (see "Replacing the hard disk
drive fan assembly" on page 175).
7. Disconnect the power cable from the simple-swap backplate.
8. Disconnect the signal cable from the system board.
9. Press and hold the drive cage release tab; then, rotate the drive cage out of the chassis until the retaining
tab on top of the cage locks into place.
10. Lift up on the retaining latch at the top of the drive cage; then, tilt the top of the simple-swap backplate
away from the drive cage until it is clear of the locating pins.
1
Retaining tab
2
Drive cage release tab
3
Locating pins
4
Simple-swap backplate
5
Retaining latch
11. Lift the simple-swap backplate out of the lower lip on the drive cage and set it aside.
12. If you are instructed to return the simple-swap backplate, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the simple-swap backplate

This procedure applies only to server models with the simple-swap SATA backplate installed on the back of
the hard disk drive cage.
.
Chapter 6 Replacing FRUs
179