Removing An Optional Tape Drive - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
Power supply support bracket
2
Power supply release tab
13. Close the bezel.
14. Install the side cover (see "Installing the side cover" on page 252).
15. Lock the side cover.
16. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
If you have other options to install or remove, do so now; otherwise go to "Completing the installation" on
page 249.

Removing an optional tape drive

To remove an optional full-high tape drive, complete the following steps:
Step 1. Read the safety information (see Chapter 2 "Safety information" on page 3).
Step 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
Step 3. Unlock and the side cover (see "Removing the side cover" on page 146).
Step 4. Open the bezel. Place your finger on the pull point area on the left side of the bezel door and
rotate it away from the server.
Step 5. Rotate the power-supply cage assembly out of the chassis. Lift up the power-supply cage handle
and pull the power-supply cage assembly all the way up until the retainer latch locks the cage in
place on the chassis.
1
Power supply
2
Power-supply handle
Step 6. Remove the air baffle (see "Removing the air baffle" on page 147e).
Step 7. Remove the fan cage assembly. Press in on the fan cage assembly release buttons on the sides of
the chassis to release the fan cage assembly from the connector on the chassis. Lift the fan cage
assembly up and out of the chassis and set it aside.
170
ThinkServer TD200 Hardware Maintenance Manual