Installing A Tape Drive - Lenovo System x3100 M4 Installation And Service Manual

Attention: Do not allow the server to fall over.
12. Connect the power (power connector P9) and signal cables to the drive.
Note: Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
If you have other devices to install, do so now. Otherwise, go to
To install a DVD drive on the 5U server model with hot-swap power supplies (Model name: 2582-F4x),
complete the following steps. For 4U server models with non-hot-swap power supplies, please see the
above sub-section.
1. Touch the static-protective package that contains the new DVD drive to any unpainted metal surface on
the server; then, remove the DVD drive from the package and place it on a static-protective surface.
2. Follow the instructions that come with the drive to set jumpers or switches, if there are any.
Note: You might find it easier to install the new drive from the front and then attach the cables.
3. Attach the drive retainer clip that you removed from the previous drive to the side of the new drive.
4. Push the drive into the bay.
5. Connect the power and signal cables to the drive.
Note: Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
If you have other devices to install, do so now. Otherwise, go to

Installing a tape drive

Use this information to install a tape drive
If you are replacing a drive, make sure that:
• You have all the cables and other equipment that is specified in the documentation that comes with the
new drive.
Drive retainer clip
"Completing the installation" on page
"Completing the installation" on page
.
Chapter 2 Installing optional devices
70.
70.
49