Installing A Cd-Rw/Dvd Drive; Removing A Tape Drive - Lenovo ThinkServer RD220 3797 Series Installation And User Manual

Installing a CD-RW/DVD drive

To install the replacement CD-RW/DVD drive, complete the following steps.
1. Attach the drive-retention clip 1 to the side of the drive.
2. Slide the drive into the CD/DVD drive bay (using the alignment pins 2 ) until
3. Install the cover (see "Completing the installation" on page 100).
4. Slide the server into the rack.
5. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing a tape drive

The following illustration shows how to remove an optional tape drive from the
server.
To remove a tape drive from the server, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Slide the server out of the rack; then, remove the cover (see "Removing the
4. Open the tape drive tray release latch 3 and slide the drive tray out of the bay
5. Disconnect the power and signal cables from the rear of the tape drive.
90
ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide
the drive clicks into place.
peripheral devices and the server.
1
SAS riser card
on page 33.
all external cables.
cover" on page 37).
approximately 25 mm (1 inch).