Table of Contents
Advertisement
Figure 39. Installing the drive
7. Connect the SATA signal cable and power cable to the new non-hot-swap drive.
Tape drive
Your server supports RDX and LTO tape drives.
• "Removing a tape drive" on page 64
• "Installing a tape drive" on page 65
Removing a tape drive
To remove a tape drive, do the following:
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 49.
2. Open the front door (available on some models).
3. Locate the upper optical drive bay. Then, disconnect the signal cable and the power cable from the rear
of the tape drive.
4. Pivot the release button outward and push the tape drive from the rear until it is projected from the front
of the chassis. Then, hold the tape drive and completely slide it out of the chassis.
64
ThinkServer TS450 User Guide and Hardware Maintenance Manual
Advertisement
Table of Contents
