Removing An Optional Tape Drive; Installing A Usb Or Sata Tape Drive - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Removing an optional tape drive

1
EMC shield
2
Tape drive
To remove an optional tape drive, do the following:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and peripheral devices; then, disconnect the power cords and all external cables.
3. Unlock and remove the left-side cover (see Removing the left-side cover).
4. Open the bezel (see Opening the bezel).
5. Remove the power supply or power supplies from the power-supply cage (see Removing a hot-swap
power supply).
6. Rotate the power-supply cage to its open position (see Opening the power-supply cage).
7. Remove the air baffle (see Removing the air baffle).
8. Remove the fan-cage assembly (see "Removing the fan cage assembly" on page 166).
9. Disconnect the drive signal cable from the system board.
10. Disconnect the power cable from the back of the tape drive.
11. If the tape drive is secured to the server with screws, remove them.
12. Gently pull the tape drive and signal cable out of the server.
13. If you are instructed to return the tape drive, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.

Installing a USB or SATA tape drive

The server supports USB and SATA tape drives. When you install a tape drive, be sure to connect the
internal tape cable to the correct connector on the system board.
182
ThinkServer TD200x Hardware Maintenance Manual