Table 9-2 Domain Access Control Register Bit Assignments - Epson ARM720T Core Cpu Manual

The Domain Access Control Register bit assignments are shown in Table 9-2.

Table 9-2 Domain Access Control Register bit assignments

Bit Function
31:28 Contain a fixed pattern that denotes the EmbeddedICE-RT version number. This must be:
• b0111 when using MRC operation to read it
• b0100 when using scan operation to read it.
27:2 SBZ
1 The write control bit.
If this bit is clear, the DCC data write register is ready to accept data from the processor.
If this bit is set, there is data in the DCC data write register and the debugger can scan it out.
0 The read control bit.
If this bit is clear, the DCC data read register is ready to accept data from the debugger.
If this bit is set, the DCC data read register contains new data that has not been read by the
processor, and the debugger must wait.
If execution is halted, bit 0 might remain asserted. The debugger can clear it by
Note:
writing to the Domain Access Control Register.
Writing to this register is rarely necessary, because in normal operation the
processor clears bit 0 after reading it.
Instructions
The following instructions must be used:
MRC CP14, 0, <Rd>, C0, C0
MCR CP14, 0, <Rn>, C1, C0
MRC CP14, 0, <Rd>, C1, C0
The Thumb instruction set does not contain coprocessor instructions, so it is
Note:
recommended that these are accessed using SWI instructions when in Thumb
state.
ARM720T CORE CPU MANUAL
Returns the value from the Domain Access Control Register into
the destination register Rd.
Writes the value in the source register Rn to the DCC data write
register.
Returns the value from the DCC data read register into the
destination register Rd.
EPSON
9: Debugging Your System
9-15