8.5.3
Seam pattern sequences
8.5.3.1 Switching the sequence programming mode on or off
Changeover from the seam pattern operation to the seam pattern
sequence operation
–
Actuate the function key "S" while the main menu is being
displayed in order to skip to the sequence programming mode.
–
Start the editing by actuating the „OK " key
–
Select any sequence by using the "ñ " key (1-25)
–
Confirm the selection by actuating the „OK" key.
The seam pattern sequence operation is switched on.
–
Actuate the key „ESC " or the "ï " key.
The main menu for the seam pattern sequence operation will be
displayed
–
The menu items sequence number and sequence in the main menu
will be described at the end of this section.
0
1
29