03130031-2F22/03130031-2F23/03130031-2F2D Purge Motor Driving Error; 03130031-2F2A Feed Roller Home Position Error; 03130031-2F3A Valve Open/Close Error; 03130031-2F2E Roll Media Feeding Error - Canon iPF9000 series Service Manual

Chapter 6

6.1.3.37 03130031-2F22/03130031-2F23/03130031-2F2D Purge motor driving error

iPF9000
<Cause>
The purge motor did not reach the specified speed within the specified time.
<Probable fault location>
Purge unit or main controller PCB
<Countermeasure>
1) Visual check
Remove foreign substance from purge unit if any.
2) Replace the purge unit.
3) Replace the main controller PCB.

6.1.3.38 03130031-2F2A Feed roller home position error

iPF9000
<Cause>
During power-on, the feed roller HP sensor could not detect that the reference of Scale that exists on encoder film area color change from transparent to black.
<Probable fault location>
Feed roller encoder film, feed roller encoder, feed roller HP sensor, feed motor, or main controller PCB
<Countermeasure>
1) Visual check
Remove foreign substances from the feed roller encoder film if any.
2) Feed roller sensor unit
Check for normal operation. If the operation is abnormal, replace the feed roller sensor unit.
3) Replace the feed roller encoder film (pully unit).
4) Replace the feed motor.
5) Replace the main controller PCB.

6.1.3.39 03130031-2F3A valve open/close error

iPF9000
<Cause>
When the ink supply valve opened or closed, valve open/closed detection sensor could not detect the valve cam rotation.
<Probable fault location>
Valve open/closed detection sensor, valve motor, or main controller PCB
<Countermeasure>
1) Visual check
Remove foreign substances from the motor, gear, and sensor of the valve open/close mechanism if any.
2) Replace the ink supply drive unit.
3) Replace the main controller PCB.

6.1.3.40 03130031-2F2E Roll media feeding error

iPF9000
<Cause>
The media sensor could not detect the media within the specified time.
<Probable fault location>
Media, media sensor, roll media feeding unit, or main controller PCB
<Countermeasure>
1) Visual check
If the media is bent, set the media once again.
2) Replace the media sensor.
3) Replace the roll media feeding unit.
4) Replace the main controller PCB.

6.1.3.41 03130031-2F28 Lift motor time out error

iPF9000
<Cause>
The lift cam sensor could not detect the home position of the lift motor within the specified time.
<Probable fault location>
Lift cam, lift cam sensor, lift drive unit, or main controller PCB
<Countermeasure>
1) Visual check
Remove foreign substances from the lift cam or the lift drive unit if any.
2) Replace the lift cam.
3) Replace the lift cam sensor.
4) Replace the lift drive unit.
5) Replace the main controller PCB.
6-12
0014-2780
0013-6978
0013-6979
0014-2781
0014-2787