Xfp Port Cabling Specifications; Xfp Optical Transmit And Receive Specifications - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
Figure 3-46
The 1-Port 10-Gigabit Ethernet SPA only accepts the XFP modules listed as supported in this document.
Note
An XFP check is run every time an XFP module is inserted into the 1-Port 10-Gigabit Ethernet SPA and
only XFP modules that pass this check are usable by the 1-Port 10-Gigabit Ethernet SPA. The
information in this document pertains only to XFP modules that plug into the 1-Port 10-Gigabit Ethernet
SPA ports.

XFP Port Cabling Specifications

Table 3-26
Table 3-26
XFP
Cisco Multirate 10GBASE-LR
and OC-192/STM-64 SR-1 XFP
Module for SMF
Cisco Multirate 10GBASE-ER
and OC-192/STM-64 IR-2 XFP
2
Module for SMF
Cisco Multirate 10GBASE-ZR
and OC-192/STM-64 IR-2 XFP
Module for SMF
1. Minimum cabling distance for optical XFP module is 2 meters, according to the IEEE 802.3ae standard.
2. Requires 5 dB 1550 nm fixed loss attenuator for < 20 km. Attenuator is available as a spare. The part number is 15216-ATT-LC-5=. You must
use a 5 to 10dB of attenuation when connecting a fiber loopback to the XFP optical port. Connection of a direct fiber loopback to the XFP can
permanently damage the port's optics.
3. Links longer than 30 km are considered engineered links.

XFP Optical Transmit and Receive Specifications

Table 3-27
OL-5052-14
XFP Illustration
provides XFP port cabling specifications.
XFP Port Cabling Specifications
Wavelength Cable Type
1310 nm SMF
1550 nm SMF
1550 nm SMF
provides XFP optical transmit and receive specifications.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
1-Port 10-Gigabit Ethernet SPA Overview
Core Size
(micron) Cable Distance
G652 10 km (10 Gigabit Ethernet)
3
G652 40 km (10 Gigabit Ethernet)
3
G652 80 km (10 Gigabit Ethernet)
1
3-53