Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual page 88

1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs
The 1-Port OC-192c/STM-64 POS/RPR XFP SPA has six LEDs, as shown in
Figure 3-35
1
2
3
The WRAP, PASSTHRU, and MATESYNC LEDs apply to the SPA in RPR/SRP mode only. As of,
Note
RPR/SRP mode is not supported.
Table 3-20
Table 3-20
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-42
1-Port OC-192c/STM-64 POS/RPR XFP SPA Faceplate
1 3
2
WRAP LED
PASSTHRU LED
MATESYNC LED
describes the 1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs.
1-Port OC-192c/STM-64 POS/RPR XFP SPA LEDs
Color State
Off Off
Green On
Amber On
Off Off
Amber On
Off Off
Green On
Off Off
Green On
Amber On
Blinking SRP mode mismatch alarm is indicated.
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
4
5
4
CARRIER LED
5
ACTIVE LED
6
STATUS LED
Meaning
Port is not in wrap mode.
Port is in wrap mode somewhere on the ring.
Port is in wrap mode locally.
Port is not in pass-thru mode.
Port is in pass-thru mode.
Mate port is not synchronized.
Mate port is synchronized.
Port is not enabled by software.
Port is enabled by software, and there is a valid SONET signal
without alarms.
Port is enabled by software, and there is at least one alarm (LOS,
LOF, RDI, and so on).
Figure 3-35.
SPA-0C192POS-XFP
6
OL-5052-14