1-Port Oc-192C/Stm-64 Pos/Rpr Spa Interface Specifications - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
The 1-Port OC-192c/STM-64 POS/RPR SPA LEDs are described in
Table 3-19 1-Port OC-192c/STM-64 POS/RPR SPA LEDs
LED Label
WRAP
PASSTHRU
MATESYNC
CARRIER
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR SPA contains a SONET/SDH framer to process incoming and
outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95 Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR SPA interface is compliant with the following RFCs:
•
•
•
The 1-Port OC-192c/STM-64 POS/RPR SPA also provides support for SNMP v1 agent
(RFC 1155–1157) and RFC 1213:
•
•
•
OL-5052-14
Color
Off
Green
Amber
Off
Amber
Off
Green
Off
Green
Amber
Off
Green
Amber
Off
Green
Amber
RFC 1619, PPP over SONET/SDH
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
RFC 1155, Structure and Identification of Management Information for TCP/IP-Based Internets
RFC 1156, Management Information Base for Network Management of TCP/IP-Based Internets
RFC 1157, Simple Network Management Protocol (SNMP)
State Meaning
Off Port is not in wrap mode.
On Port is in wrap mode somewhere on the ring.
On Port is in wrap mode locally.
Off Port is not in pass-thru mode.
On Port is in pass-thru mode.
Off Mate port is not synchronized.
On Mate port is synchronized.
Off Port is not enabled by software.
On Port is enabled by software; there is a valid SONET signal
without alarms.
On Port is enabled by software; there is at least one alarm (LOS,
LOF, RDI, and so on).
Blinking Indicates SRP mode mismatch alarm.
Off Port is not enabled by software.
On Port is enabled by software; loopback is off.
On Port is enabled by software; loopback is on.
Off SPA power off.
On SPA is ready and operational.
On SPA power is on and good; SPA is being configured.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
1-Port OC-192c/STM-64 POS/RPR SPA Overview
Table 3-19.
3-39