Preparing For Online Removal Of A Spa - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Online Insertion and Removal
The following example shows that the Cisco 7600 SIP-400 located in slot 13 is deactivated. This is
indicated by its "PwrDown" status.
Router# show module 13
Mod Ports Card Type
--- ----- -------------------------------------- ------------------ -----------
13
Mod MAC addresses
--- ---------------------------------- ------ ------------ ------------ -------
13
Mod Online Diag Status
--- -------------------
13 PwrDown
To verify activation and proper operation of a SIP, enter the show module command and observe "Ok"
in the Status field as shown in the following example:
Router# show module 2
Mod Ports Card Type
--- ----- -------------------------------------- ------------------ -----------
2
Mod MAC addresses
--- ---------------------------------- ------ ------------ ------------ -------
2
Mod Online Diag Status
--- -------------------
2 Pass

Preparing for Online Removal of a SPA

The Cisco 7600 series router supports OIR of a SPA independently of removing the SIP or SSC. This
means that a SIP can remain installed in the router with one SPA remaining active, while you remove
another SPA from one of the SIP subslots. If you are not planning to immediately replace a SPA into the
SIP, then be sure to install a blank filler plate in the subslot. The SIP should always be fully installed
with either functional SPAs or blank filler plates.
The interface configuration is retained (recalled) if a SIP or SPA is removed and then replaced with one
of the same type. This is not the case if you replace a Cisco 7600 SIP-200 with a Cisco 7600 SIP-400 or
vice versa.
If you are planning to remove a SIP along with its SPAs, then you do not need to follow the instructions
in this section. To remove a SIP, see the
page
If you move the SPA (SPA-8XTE1/ SPA-4xCT3/DS0 / SPA-2xCT3/DS0/SPA-1xCHSTM1/OC3) from
Note
one LC to another type of LC in the same bay and same slot, the system will not retain the configuration
of the old interface.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
5-4
0 4-subslot SPA Interface Processor-400
00e0.aabb.cc00 to 00e0.aabb.cc3f
0 4-subslot SPA Interface Processor-200
0000.0000.0000 to 0000.0000.003f
5-2.
Model
7600-SIP-400
Hw Fw
0.525 12.2(PP_SPL_ 12.2(PP_SPL_ Ok
Model
7600-SIP-200
Hw Fw
0.232 12.2(2004082 12.2(2004082 Ok
"Preparing for Online Removal of a SIP or SSC" section on
Chapter 5 Installing and Removing a SIP
Serial No.
JAB0851042X
Sw Status
Serial No.
JAB074905S1
Sw Status
OL-5052-14