Cisco 7600 Sip-200 Default Dip Switch Settings; Cisco 7600 Sip-400 Overview - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Cisco 7600 SIP-400 Overview

Cisco 7600 SIP-200 Default DIP Switch Settings

If SW3 and SW10 switches are present on the board, make sure they are set to the default settings, as
shown in
The switches are set to their defaults during manufacture. However, the switch settings may get
inadvertently changed during handling.
If the switches are not set to their default settings, there may be momentary packet drops during OIR of
Note
the board.
Table 2-6 Cisco 7600 SIP-200 Default DIP Settings
Switch Default Position
SW3 Up
SW10 Down
Figure 2-6 Cisco 7600 SIP-200 DIP Switch Locations
\
76 00
-M S C
-2 00
M O D
U LA R
SE RV
IC ES
C AR D
1 SW3
Cisco 7600 SIP-400 Overview
The following sections describe the Cisco 7600 SIP-400 (Cisco part number 7600-SIP-400):
•
•
•
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
2-8
Table 2-6. See Figure 2-6
2 SW10
Cisco 7600 SIP-400 Processor, page 2-9
Cisco 7600 SIP-400 LEDs, page 2-9
Cisco 7600 SIP-400 Physical Specifications, page 2-9
for the location of the switches.
Chapter 2 Overview: Cisco 7600 Series SIPs
1
2
OL-5052-14