Packing A Spa For Shipment; Packing A Sip For Shipment - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Packing a SPA for Shipment

Packing a SPA for Shipment
This section provides step-by-step instructions for packing a SPA and the cable-management brackets
for shipment. Before beginning this procedure, you should have the following original Cisco Systems
packaging materials:
•
•
Use Cisco Systems original packaging for the shipment of all SPAs and cable-management brackets.
Caution
Failure to properly use Cisco Systems packaging can result in damage or loss of product.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
These instructions assume that the SPA and cable-management brackets have been removed from the
Note
router according to the recommended procedures specified in this guide.
To pack a SPA and the cable-management brackets for shipment, follow these steps:
Open the thermoform container and place the SPA and each of the cable-management brackets into the
Step 1
appropriate cavities.
Always handle the SPA by the carrier edges and handle; never touch the SPA components or connector
Caution
pins.
Close the thermoform container. Be sure to lock the snaps securely.
Step 2
Check that the thermoform container is fully closed. Apply tape or a label closure over the opening to
Step 3
ensure that the container stays closed during shipping.
Place the thermoform container into the carton.
Step 4
Close the carton.
Step 5
Apply tape over the carton flap to ensure that the carton stays closed during shipping.
Step 6

Packing a SIP for Shipment

This section provides step-by-step instructions for packing a SIP for shipment. Before beginning this
procedure, you should have the following original Cisco Systems packaging materials:
•
•
•
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
7-8
Thermoform container (transparent plastic-molded clamshell)
Carton
Static shielding bag
Smaller inner carton
Larger exterior carton
Chapter 7 Troubleshooting the Installation
OL-5052-14