8-Port Channelized T1/E1 Spa Interface Specifications - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

8-Port Channelized T1/E1 SPA Overview
Figure 3-3
1
2
The 8-Port Channelized T1/E1 SPA LEDs are described in
Table 3-6
LED Label
C/A
A/L
STATUS

8-Port Channelized T1/E1 SPA Interface Specifications

The E1 interface on the 8-Port Channelized T1/E1 SPA uses RJ-48c receptacles for E1 (120-Ohm) cables
with RJ-45 connectors. You can use all ports simultaneously. Each E1 connection supports interfaces that
meet G.703 standards. The RJ-45 connection does not require an external transceiver. The E1 ports are
E1 interfaces that use 120-ohm shielded twisted pair (STP) cables.
Warning Shielded twisted pair (STP) T1/E1 cables must be used to comply with EN55022/CISPR22 Class A
emissions requirements. For revisions 73-8358-05 through 73-8358-08 Shielded Twisted pair (STP)
T1/E1 cables must be used to comply with FCC Class A emissions requirements.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-10
8-Port Channelized T1/E1 SPA Faceplate
2
1
C/A A/L C/A
C/A (Carrier/Alarm) LED
A/L (Active Loopback) LED
8-Port Channelized T1/E1 SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
Off
Amber
Green
Chapter 3
A/L C/A A/L C/A A/L C/A
3
State Meaning
Off Port is not enabled by software.
On Port is enabled by software, and there is a valid T1 or E1
signal without any alarms.
On Port is enabled by software, and there is at least one alarm.
Off Port is not enabled by software.
On Port is enabled by software, loopback is off.
On Port is enabled by software, loopback is on.
Off SPA power is off.
On SPA power is on and good, and SPA is being configured.
On SPA is ready and operational.
Overview: Cisco 7600 Series Router Shared Port Adapters
A/L C/A A/L C/A A/L C/A
STATUS LED
Table 3-6.
A/L
3
OL-5052-14