Cisco 7600 Sip-200 Memory Options; Cisco 7600 Sip-200 Memory Installation And Removal - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Chapter 2 Overview: Cisco 7600 Series SIPs

Cisco 7600 SIP-200 Memory Options

The following table lists the memory available for the Cisco 7600 SIP-200:
Table 2-5
SIP
Cisco 7600 SIP-200
The SIP DIMMs must be a matched set. A warning message appears on the console if the DIMMs on the
Note
SIP are different sizes. If the sizes are not the same, the following message appears at bootup/OIR:
C7600_SIP200-3-MEM_MODULE_MISMATCH: Memory modules are not identical

Cisco 7600 SIP-200 Memory Installation and Removal

Figure 2-5
to install and remove a DIMM:
To install a DIMM, slide the DIMM into the slot. The retaining clips secure the DIMM in place.
To remove a DIMM, separate the two retaining clips.
Step 1
Pull the DIMM from the slot.
Step 2
Figure 2-5
76 00
-M S C
-2 00
M O D
U LA R
SE RV
IC ES
C AR D
1
OL-5052-14
SIP Memory Options
Memory Options
512 MB and 1 GB (2 x 256-MB or 2 x 512-MB DIMMs)
shows the location of the DIMMs on a Cisco 7600 SIP-200. Perform the following procedure
SIP DIMM Location
DIMMs
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
Cisco 7600 SIP-200 Overview
1
2-7