2-Port Gigabit Ethernet Spa Leds; 2-Port Gigabit Ethernet Spa Cables And Connectors; Sfp Module Connections - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters

2-Port Gigabit Ethernet SPA LEDs

The 2-Port Gigabit Ethernet SPA has two types of LEDs. There is an A/L LED for each port and one
STATUS LED as shown in
Figure 3-47
1
The 2-Port Gigabit Ethernet SPA LEDs are described in
Table 3-29
LED Label
A/L
STATUS

2-Port Gigabit Ethernet SPA Cables and Connectors

The interface connectors on the 2-Port Gigabit Ethernet SPA are two individual fiber optic receivers that
support SFP modules. Each port can send and receive traffic using the optical fiber connections.

SFP Module Connections

The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet optical slots on the 2-Port Gigabit Ethernet SPA, linking the port with a 1000BASE-X
fiber-optic network.
The 2-Port Gigabit Ethernet SPA will only accept the SFP modules listed as supported in this document.
Note
An SFP check is run every time an SFP module is inserted into the 2-Port Gigabit Ethernet SPA and only
SFP modules that pass this check will be usable by the 2-Port Gigabit Ethernet SPA.
OL-5052-14
Figure
2-Port Gigabit Ethernet SPA Faceplate
A/L LED (for each interface)
2-Port Gigabit Ethernet SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
3-47.
1
2
State Meaning
Off Port is not enabled.
On The port is enabled and the link is up.
On The port is enabled and the link is down.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and SPA is being configured.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
2-Port Gigabit Ethernet SPA Overview
SPA-2X1GE--V2
2
STATUS LED (for entire SPA)
Table 3-29.
3-55