Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual page 75

Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
Figure 3-23
The SFP optical transceiver modules used with the POS SPAs provide the following optical fiber options:
Multimode—622.08-Mbps, OC-12 optical fiber (SONET STS-12c or SDH STM-4)
•
Use a multimode optical fiber that has a core/cladding diameter of 62.5/125 microns.
Single-mode—622.08-Mbps, OC-12 optical fiber (SONET STS-12c or SDH STM-4)
•
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal
diameter is approximately 10/125 microns.)
For single-mode and multimode optical fiber connections, you can use either a duplex LC-type cable (see
Figure
Use single-mode (for intermediate- or long-reach configurations) or multimode optical fiber cable to
connect your router to a network or to connect two 1-Port OC-12c/STM-4 POS SPA-equipped routers
back to back.
Long-range SFP optical transceiver modules (for long-reach configurations) cannot be connected
back-to-back without using an attenuator between the two of them.
Figure 3-24
RX TX
OL-5052-14
SFP Optics Module
3-24) or two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
LC-Type Cable
/ /
/ /
/ /
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
1-Port OC-12c/STM-4 POS SPA Overview
3-29