Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual page 94

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview
Use a multimode optical fiber cable to connect your router to a network.
Figure 3-39
OC-192c/STM-64 POS/RPR VSR Optics SPA.
Figure 3-39
1
1
Mate Interface Cables
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA supports two mate interface configurations:
•
•
Two 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPAs are connected using a 40–pin connector
copper mate cable. The length of the cables allow only two possible connection scenarios, next slot
horizontal and same slot vertical. This assumes that the chassis is mounted vertically. Figure 3-34 shows
the mate cables used to connect the SPAs.
Figure 3-40
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-48
Use a multimode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal
diameter is approximately 10/125 microns.)
shows the cable type for use with the fixed optical transceiver module on the 1-Port
Simplex MTP Cable Connector (Multimode—VSR Only)
2
MTP female connector
Mate between two OC-192c SPAs in the same SIP
Mate between two OC-192c SPAs in adjacent SIPs
SPA Mate Cables
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
2 Spring-action disconnect latch
1
2
OL-5052-14